Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Manual de usuario descargar pdf (Pagina 190)

100

101

Running a Program

Chapter 7

7-2

When programming a slash “/” followed by a numeric value (1-9)

anywhere in a block, the control skips (not execute) all remaining motion

commands programmed commands in that block i f a corresponding

softkey or optionally installed switch on the MTB panel is activated. If the

“block delete type” parameter in AMP is set to “delete whole”, then the

control skips the entire block regardless of the position of the block delete

character. For details on the block delete feature, see page 10-1 1.

The block delete feature is activated through your system installer’s PAL

program (see documentation prepared by your system installer), or by

using the

{FRONT PANEL} softkey. If using the {FRONT PANEL} softkey,

only block delete 1 (/ or/1) is available.

When the miscellaneous function lock is m ade active, the control ignores

M, second auxiliary functions (B codes), S , and T codes in the part

program, except for M00, M01, M02, M30, M98, and M 99.

The miscellaneous function lock feature is activated through your system

installer’s PAL program (see documentation prepared by your system

installer), or by using the

{FRONT PANEL} softkey (chapter 2, page 2-11).

Use this feature to cause automatic program execution to stop after a

specified block. This block is determined by assigning its sequence

number (N word) as the sequence stop block. This sequence number can

be entered before or after part program execution begins. If this sequence

number is entered after program execution begins, it must be entered

before the control begins execution of that block. If it is not entered before

the block begins, it is ignored and execution continues as normal.

Automatic execution stops after the sequence stop block is completed. The

control is placed in cycle stop. To resume execution from the current

position in the program, press the

<CYCLE START> button.

Important: Once you enter a sequence stop number for a program, it

remains active for all programs that are executed until replaced with a

different sequence stop number, or power is lost. Not entering a value for

the sequence stop number or entering a value of zero results in the

sequence stop function being cancelled.

If you call a subprogram or macro that also contains a sequence number

that corresponds to the sequence stop number, program execution stops in

the subprogram or macro at the corresponding sequence number.

7.1.1

Block Delete

7.1.2

Miscellaneous Function

Lock

7.1.3

Sequence Stop {SEQSTOP}

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 819 820

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Manual de usuario Pagina 190

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra