Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Manual de usuario descargar pdf (Pagina 274)

Communications

3. Press the {COPY PRGRAM} softkey.

(softkey level 2)

4. Enter the program name to output from memory. Two ways to do this

are available:

Type in the program name using the alphanumeric keys on the

keyboard. The control displays program name on the input line

(line 2 of the screen) next to the prompt “FILENAME”.

Use the up and down cursor keys to position the cursor at the

program you want to send. The selected program appears in

reverse video.

If outputting all programs, cursor to the first program in your

program directory.

5. Select the device you want to copy as follows:

Ifthe p eripheral device is connected to: Press this softkey:

Port A {MEM TO PORT A}

Port B {MEM TO PORT B}

(softkey level 3)

The copy parameters screen appears (see Figure 9.4).

6. Specify ifyou want to output one, multiple, or all programs onto tape.

Output Single Program

Press {SINGLE PRGRAM} to output the program selected in

Sin comentarios

Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Manual de usuario Pagina 274