Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Manual de usuario descargar pdf (Pagina 269)

Communications

PRGRM NAME -- if set to “yes,” a program name is recognized as the

end of the previous program. The program name must be in one of

these forms where xxxxx indicates an integer from 0 to 99999:

Oxxxxx (ASCII)

:xxxxx (EIA)

Nxxxxx (except for N00000)

Important: If you use an N-code to designate the program name, be aware

that the control interprets all part program blocks that contain N-codes as

new part programs.

If you load a program on a peripheral device, such as a tape reader, and

you want to send a copy of that program to control memory, follow these

1. Verify that the peripheral device is connected to the correct serial port

and that the port is configured for that device (see page 9-1).

2. Press the {PRGRAM MANAGE} softkey.

(softkey level 1)

OFFSET MACRO

The Program Directory Screen is displayed:

Inputting Part Programs

from a Serial Peripheral

Sin comentarios

Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Manual de usuario Pagina 269