Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Manual de usuario descargar pdf (Pagina 56)

100

101

Chapter 2

Operating the Control

2-36

Block R eset

Use the block reset feature to force the control to skip the execution of a

block. To use the block reset function, you must stop program execution.

Ifprogram execution is stopped: Then:

beforethe control hascompletely finishedthe

execution ofthe block

a blockresetabortsany portionof that

blockthathasnotbeen executed.

afterthecompleteexecutionof a block(asin the

caseof single-blockexecutionora M00, etc.)

thecontrol abortstheexecuti on of the

entirefollowing block.

Press the [RESET] key on t he operator panel to perform a block reset.

When executing protected program blocks, the control displays the last

non-protected block on the C RT. If you perform a block reset during

execution of a protected program block, the protected block is reset but the

block displayed on the CRT does not change until the control encounters

an M02, M30, or M99.

Control Reset

By executing a control reset, you can:

return the control to the default parameters (except inch/metric which

remains in its last programmed state when control reset is performed).

clear any programming errors that have recently occurred

cancel any MDI commands

After the execution of a control reset:

any active program is reset to the first block

any programmed offsets or rotations to the coordinate systems are reset

to default

any MDI command is discarded

All of the initial operating param eters return to the standard AMP assigned

values including any AMP assigned G codes normally active at power-up.

Press the

[RESET] key on the operator panel while holding down the

[SHIFT] key to execute a control reset. Your system installer can also

configure AMP to force a control reset when you perform a E-Stop reset.

2.9

Control and Block Reset

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 819 820

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Manual de usuario Pagina 56

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra