Rockwell-automation SP600 User Manual Version 3.0 Manual de usuario descargar pdf (Pagina 89)

Using the Start-Up Routines on the LCD OIM

9-1

CHAPTER 9

Using the

Start-Up Routines

on the LCD OIM

For standard applications, the Start-Up routines on the LCD OIM

enable you to configure the most commonly used parameters

through a series of steps. This helps you set up the drive as quickly

as possible.

For advanced applications, you may need to adjust additional

parameters in the parameter list using either the LCD OIM or

VS Utilities

™ software.

9.1 Preparing for Start-Up

Before performing Start-Up, you must:

• be qualified to configure the drive and be familiar with the

operation of AC drives.

• be familiar with the operation of the LCD OIM.

• have completed all hardware installation as described in chapters

3 through 8 of this manual.

• properly connect the drive to the motor.

ATTENTION: Only qualified electrical personnel

familiar with the construction and operation of this

equipment and the hazards involved should install,

adjust, operate, or service this equipment. Read and

understand this chapter in its entirety before

proceeding. Failure to observe this precaution could

result in severe bodily injury or loss of life.

ATTENTION: Incorrect values for some of the

parameters in the Start-Up routines can cause the

drive to operate improperly. Verify that the values of

these parameters are appropriate for your

application. Failure to observe this precaution could

result in bodily injury.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 273 274

Sin comentarios

Rockwell-automation SP600 User Manual Version 3.0 Manual de usuario Pagina 89